Paraflyte Guard Chair - Ladder at Rear

All Paraflyte chairs have a platform height of 4'6", a seat height of 6'0" above the deck, and are supported by a stainless steel flanged pedestal which is set back 3'0" from the pool wall. The ladder at side is set back 3' 1-5/8" from the pool wall. Combination ladder risers and guard rails are .065" wall x 1.90" diameter, Type 304 stainless steel, polished to a 320 grit finish.

Paraflyte Guard Chair - Club

All Paraflyte chairs have a platform height of 4'6", a seat height of 6'0" above the deck, and are supported by a stainless steel flanged pedestal which is set back 3'0" from the pool wall. The ladder at side is set back 3' 1-5/8" from the pool wall. Combination ladder risers and guard rails are .065" wall x 1.90" diameter, Type 304 stainless steel, polished to a 320 grit finish.

Paraflyte Guard Chair - OSHA

All Paraflyte chairs have a platform height of 4'6", a seat height of 6'0" above the deck, and are supported by a stainless steel flanged pedestal which is set back 3'0" from the pool wall. The ladder at side is set back 3' 1-5/8" from the pool wall. Combination ladder risers and guard rails are .065" wall x 1.90" diameter, Type 304 stainless steel, polished to a 320 grit finish.

Vista Lifeguard Chair

The Vista lifeguard chair comes in either 6' or 8' heights that allow lifeguards to easily scan large pool areas. This easily movable unit allows you the flexibility of moving your lifeguard stations as needed. The seat swivels 360-degrees for uninhibited scanning.

Height: 6' or 8'
Required deck space: 52” x 42”

Duraflex Diving Board
The 14’ and 16' Duraflex are one piece ribbed extrusions of aluminum alloy 6070-T6, heat treated for a yield strength of 50,000 psi. It has a torsion-box extrusion, an anchor angle, and tip end cap riveted to the basic section. It is tapered from the fulcrum area to the diving tip.

The board is coated in aqua-colored thermal-curing epoxy resin. The top surface is finished with a laminate of flint silica and alumina, between coats of epoxy to effect a slip-resistant surface.

Duraflex Maxi-B
The Maxi-B is the diving board of the majority of majoir competitive diving events. The 16' Maxi-B  is a one piece ribbed extrusion of aluminum alloy 6070-T6, heat treated for a yield strength of 50,000 psi. It has a torsion-box extrusion, an anchor angle, and tip end cap riveted to the basic section. It is tapered from the fulcrum area to both the diving tip and anchor end, allowing the whole board to arc and giving it more lift than the 16' Duraflex. The Maxi-B also has slots in the metal of the top "skin" which reduces the weight of the tip-end.